Flakpanzer, Self-Propelled Anti-Aircraft Tanks Developed By Nazi Germany During World War II

Flakpanzer is a German term for “anti-aircraft tanks” (“flak” is derived from Flugabwehrkanone, literally “aircraft defence cannon”; “panzer” is derived from Panzerkampfwagen, literally “armored fighting vehicle”). These vehicles are modified tanks whose armament was intended to engage aircraft, rather than targets on the ground. Several vehicles with this name were used by the German Army during World War II. After the war, others were used by both the West German Bundeswehr and the East German National People’s Army.

By 1943, it had become apparent that the Luftwaffe was losing control of the skies, and that the need for a Flakpanzer was dire. For this reason, the German Heer (German Army) took the first steps in developing new Flakpanzer designs. Given the long development time necessary to bring a new chassis to maturity and the shortage of available production capacity, it was decided to amend existing designs to fulfill the Army’s needs. The simpler and more logical solution was to simply reuse already produced chassis. The Panzer I and II were outdated or used for other purposes. The Panzer 38(t) was used in small numbers as a temporary solution, but it was needed for anti-tank vehicles based on this chassis and, in any case, it was deemed inadequate for this task due to its small size.

The Panzer III tank chassis was used for the production of the StuG III and thus not available. The Panzer IV and the Panzer V Panther were considered next. The Panzer IV tank chassis was already in use for several German modifications, so it was decided to use it for the Flakpanzer program. The Panzer V Panther was, for a short time, considered to be used as a Flakpanzer armed with two 37 mm anti-aircraft guns, but mostly due to the high demand for tank hulls, the project never went beyond a wooden mock-up.

The first Flakpanzer based on the Panzer IV tank chassis was the 2 cm Flakvierling auf Fahrgestell Panzerkampfwagen IV. It did not receive any production orders but the prototype was modified and upgraded with the larger 3.7 cm Flak 43 (known as the Möbelwagen to its crews) and around 240 of this version were produced. The Möbelwagen had sufficient firepower to destroy enemy planes and the crew was protected by armored plates on four sides, which needed to be dropped down to use the gun effectively. The Möbelwagen needed time to set up for action and was therefore not a success.

It was apparent that a Flakpanzer with a fully rotating turret, enclosed on all sides and open-topped, was needed. For this reason, in early 1944, Generaloberst Guderian, Generalinspekteur der Panzertruppen (Inspector-General for Armored Troops), gave In 6 (Inspektion der Panzertruppen 6/ Armored Troops Inspection Office 6) direct orders to begin work on a new Flakpanzer.